</>EmbeddedInterview

What is a decoupling capacitor and where should it be placed?

EasyElectronics & Hardware Basics

Short answer: A decoupling (bypass) capacitor is placed between a chip's supply pin and ground, as close to the pin as possible, to supply the short bursts of current the chip draws when its transistors switch. Without it, those current spikes flowing through the inductance of the power traces cause the supply voltage at the pin to dip and ring, leading to resets, data errors and noise. The usual practice is 100 nF ceramic per supply pin, plus 1–10 µF bulk capacitance per chip or power domain.

Why close to the pin: a trace has roughly 1 nH per mm of inductance; V = L × di/dt, so even a few nH with fast current edges creates significant voltage drops. The capacitor must be in a small loop: pin → capacitor → ground via → ground plane, with the via right next to the pad.

Choosing capacitors

Value Role
10–100 nF ceramic (X7R/X5R) at each pin high-frequency current
1–10 µF ceramic per chip/rail mid-frequency, local reservoir
10–100+ µF (ceramic, tantalum, polymer) at the regulator / board input bulk, low-frequency load steps
Ferrite bead + capacitors isolate analog supplies (AVDD, VREF+) from digital noise

Details interviewers like

  • Ceramic capacitors lose capacitance with DC bias and temperature (a 10 µF 6.3 V 0603 part may give only 3–5 µF at 3.3 V).
  • Each capacitor has a self-resonant frequency set by its ESL; above it the capacitor behaves like an inductor, which is why several values or many small capacitors are used in parallel.
  • Many MCUs require specific capacitors on internal regulator pins (e.g. VCAP on STM32F4: 2.2 µF low-ESR) — missing them causes the MCU not to start or crash randomly.
  • Firmware symptom of poor decoupling: random resets or hard faults when radios transmit, motors start or the CPU frequency increases.