How do you interface a 3.3 V MCU with a 5 V device?
Short answer: Check both directions against the datasheets. 3.3 V → 5 V: the 5 V device may accept 3.3 V as a valid high (many TTL-compatible inputs need only V_IH ≈ 2.0 V); if it needs 0.7 × VDD = 3.5 V (CMOS), use a level shifter or an open-drain output with a pull-up to 5 V (only if the MCU pin is 5 V tolerant). 5 V → 3.3 V: never connect directly unless the MCU pin is specified as 5 V tolerant; otherwise use a resistor divider, a series resistor (limiting current into the protection diode, not a robust design), or a buffer powered at 3.3 V with 5 V-tolerant inputs.
Options
| Method | Direction | Speed | Notes |
|---|---|---|---|
| Direct connection | 3.3 → 5 V | fast | only if 5 V device's V_IH ≤ ~2.4 V (TTL-level inputs, 74HCT) |
| Resistor divider (e.g. 1.8 kΩ / 3.3 kΩ) | 5 → 3.3 V | moderate (RC with input capacitance) | simple, one direction |
| 5 V-tolerant MCU pin | 5 → 3.3 V | fast | check "FT" pins and that they are not in analog mode |
| Unidirectional buffer (74LVC1T45, 74AHCT125) | either | fast | proper solution for SPI, UART, clock lines |
| MOSFET bidirectional shifter (BSS138 + pull-ups) | both | slow–moderate (≤ ~400 kHz–1 MHz) | standard for I2C |
| Auto-direction translators (TXB/TXS0108) | both | varies | TXS for open-drain, TXB for push-pull; can misbehave with strong pull-ups/loads |
Things to check
- Power sequencing/back-powering: if the 5 V device is powered while the 3.3 V MCU is off, current can flow through input protection diodes and partially power the MCU, causing latch-up or strange behaviour. Use translators with power-off protection (I_off).
- Thresholds: V_OH of the driver must exceed V_IH of the receiver with margin, and V_OL must be below V_IL.
- Speed: dividers and MOSFET shifters slow edges; fast SPI needs a proper buffer.
- Analog signals: use a divider sized for the ADC input impedance, possibly with an op-amp buffer.