</>EmbeddedInterview

What is the NVIC?

EasyMicrocontrollers & ARM Cortex-M

Short answer: The Nested Vectored Interrupt Controller is the interrupt controller built into every Cortex-M core. It enables and disables each external interrupt, records pending interrupts, assigns programmable priorities, lets higher-priority interrupts pre-empt lower ones (nesting), and fetches the handler address directly from the vector table (vectored), with hardware optimisations such as tail-chaining and late arrival.

What it provides

  • Enable/disable per IRQ: NVIC_EnableIRQ(USART2_IRQn), NVIC_DisableIRQ() (registers ISER/ICER).
  • Pending state: set or clear by software (NVIC_SetPendingIRQ, NVIC_ClearPendingIRQ), useful for testing or deferring work to a software-triggered interrupt.
  • Active state: which interrupts are currently running (nesting).
  • Priorities: 2 bits on Cortex-M0/M0+ (4 levels), typically 3–8 bits on M3/M4/M7/M33 (e.g. 16 levels on STM32), set with NVIC_SetPriority().
  • Priority grouping into pre-emption priority and sub-priority (not on v6-M).
  • Number of interrupts: up to 32 on Armv6-M, up to 240 on Armv7-M, up to 480 on Armv8-M Mainline, depending on the chip.

Typical set-up

NVIC_SetPriority(USART2_IRQn, 5);     /* CMSIS shifts into the implemented bits */
NVIC_ClearPendingIRQ(USART2_IRQn);    /* drop anything pending from before */
NVIC_EnableIRQ(USART2_IRQn);
USART2->CR1 |= USART_CR1_RXNEIE;      /* and enable the source inside the peripheral */

An interrupt reaches the CPU only if it is enabled both in the peripheral and in the NVIC (and not masked by PRIMASK/BASEPRI).

Level vs pulse interrupts: most peripheral interrupts are level-sensitive: the line stays asserted until the peripheral's flag is cleared. If the handler does not clear it, the interrupt is taken again immediately after return.

Related: system exceptions (SysTick, PendSV, SVC, faults) are configured in the SCB (SCB->SHPR), not the NVIC. WIC (wake-up interrupt controller) lets interrupts wake the core from deep sleep when the NVIC clock is stopped. Cortex-A systems use the GIC instead.