What is the difference between flash and EEPROM, and what is wear levelling?
Short answer: Both are non-volatile memories. Flash is erased in large blocks (sectors or pages, typically 1–128 KB on MCUs) and programming can only change bits from 1 to 0; to change a 0 back to 1 you must erase the whole block. EEPROM can usually be erased and written byte by byte. Both wear out after a limited number of erase/write cycles (typically 10,000 for MCU flash, 100,000 to 1,000,000 for EEPROM). Wear levelling spreads writes across many locations so no single block reaches its limit early.
| Flash (MCU embedded) | EEPROM | |
|---|---|---|
| Erase unit | sector/page (KBs) | byte or word |
| Write unit | word/double-word/row (bits 1 → 0 only) | byte |
| Endurance | ~10k cycles (some 100k) | 100k–1M cycles |
| Retention | 10–20 years | 10–100 years |
| Speed | erase ms (sector: up to seconds), program µs | write ~3–5 ms per byte/page |
| Density / cost | high / low | low / higher |
| Reads while writing | usually blocks reads of the same bank | independent (external EEPROM) |
Emulated EEPROM on flash (common technique)
- Use two (or more) flash pages. Store records as (ID, value) pairs appended sequentially.
- To update a value, append a new record; the newest record for an ID is valid.
- When a page fills, copy the latest value of each ID to the other page, then erase the old page.
- Each erase now covers many updates, multiplying the effective endurance.
Wear levelling in general: log-structured storage, rotating sectors, keeping erase counts per block. Filesystems like LittleFS (MCU), UBIFS and F2FS (Linux) do this; managed flash (eMMC, SD) has a controller that does it internally.
Power-loss safety: a write or erase interrupted by power failure leaves a half-programmed area. Use sequence numbers and CRCs per record, write the new copy before invalidating the old, and validate at boot.
Endurance calculation example: writing a 32-byte record every minute to a 2 KB page pair with 10k cycles: each page holds 64 records → one erase per 64 minutes per page, alternating → each page erased about every 2 hours → 10k cycles last ~2.3 years. Using 8 pages instead extends it ~4×. Interviewers like to see this kind of estimate.