</>EmbeddedInterview

How does power management work for drivers (system suspend and runtime PM)?

HardLinux Kernel & Device Drivers

Short answer: Drivers implement two kinds of power management through dev_pm_ops. System sleep callbacks (suspend/resume, plus _late/_noirq variants) save state and power the device down when the whole system suspends (to RAM or disk), then restore it. Runtime PM (runtime_suspend/runtime_resume) powers an individual device down whenever it is idle while the system runs: the driver calls pm_runtime_resume_and_get() before using the hardware and pm_runtime_put_autosuspend() when done, and the core suspends it after an autosuspend delay when the usage count reaches zero.

static int mydev_runtime_suspend(struct device *dev)
{
    struct mydev *d = dev_get_drvdata(dev);
    clk_disable_unprepare(d->clk);
    return regulator_disable(d->vdd);
}

static int mydev_runtime_resume(struct device *dev)
{
    struct mydev *d = dev_get_drvdata(dev);
    int ret = regulator_enable(d->vdd);
    if (ret) return ret;
    ret = clk_prepare_enable(d->clk);
    if (ret) { regulator_disable(d->vdd); return ret; }
    regcache_cache_only(d->map, false);
    return regcache_sync(d->map);                 /* restore registers after power loss */
}

static const struct dev_pm_ops mydev_pm = {
    RUNTIME_PM_OPS(mydev_runtime_suspend, mydev_runtime_resume, NULL)
    SYSTEM_SLEEP_PM_OPS(pm_runtime_force_suspend, pm_runtime_force_resume)
};
/* .driver.pm = pm_ptr(&mydev_pm) */

/* in probe */
pm_runtime_set_autosuspend_delay(dev, 200);
pm_runtime_use_autosuspend(dev);
devm_pm_runtime_enable(dev);

/* around each hardware access */
ret = pm_runtime_resume_and_get(dev);
if (ret) return ret;
do_transfer(d);
pm_runtime_mark_last_busy(dev);
pm_runtime_put_autosuspend(dev);

Concepts to mention

  • Device hierarchy: children suspend before parents and resume after them; device links handle non-parent dependencies (fw_devlink).
  • PM domains (genpd): power islands shared by several devices, switched off when all are runtime-suspended.
  • Wake-up sources: device_init_wakeup(), enable_irq_wake() so a button or RTC can wake the system.
  • Clocks and voltages: DVFS via OPP tables and cpufreq/devfreq; interconnect bandwidth votes.
  • Debugging: /sys/devices/.../power/runtime_status, /sys/kernel/debug/pm_genpd/, echo mem > /sys/power/state, pm_test, and no_console_suspend to see messages during suspend.