Topics / Embedded C / Q15
What is the vector table?
Short answer: The vector table is an array of addresses that the CPU uses to find handlers for exceptions and interrupts. On Cortex-M it is at address 0 by default (relocatable with SCB->VTOR): entry 0 is the initial main stack pointer, entry 1 is the reset handler, then the system exception handlers (NMI, HardFault, MemManage, BusFault, UsageFault, SVCall, DebugMonitor, PendSV, SysTick), followed by one entry per peripheral interrupt (IRQ0, IRQ1, ...).
| Offset | Entry | Exception number |
|---|---|---|
| 0x00 | Initial MSP value | – |
| 0x04 | Reset | 1 |
| 0x08 | NMI | 2 |
| 0x0C | HardFault | 3 |
| 0x10–0x18 | MemManage, BusFault, UsageFault (not on M0/M0+) | 4–6 |
| 0x1C–0x28 | SecureFault (v8-M) / reserved | 7–10 |
| 0x2C | SVCall | 11 |
| 0x30 | DebugMonitor | 12 |
| 0x38 | PendSV | 14 |
| 0x3C | SysTick | 15 |
| 0x40 + 4·n | IRQn (peripheral interrupts) | 16 + n |
In C (GCC):
extern uint32_t _estack;
void Reset_Handler(void);
void Default_Handler(void) { for (;;) { } }
void NMI_Handler(void) __attribute__((weak, alias("Default_Handler")));
void HardFault_Handler(void) __attribute__((weak, alias("Default_Handler")));
void USART2_IRQHandler(void) __attribute__((weak, alias("Default_Handler")));
__attribute__((section(".isr_vector"), used))
void (*const vector_table[])(void) = {
(void (*)(void))&_estack,
Reset_Handler,
NMI_Handler,
HardFault_Handler,
/* ... */
};
Details
- Handler addresses have bit 0 set (Thumb state); the compiler/linker does this automatically for function addresses.
VTORalignment: the table must be aligned to a power of two at least as large as the table (e.g. 512 bytes for up to 128 entries); check the core's rules.- Relocating the table to RAM lets you change handlers at run time and is needed by bootloaders (the application sets
VTORto its own table). - Cortex-A uses a different scheme: a table of instructions (branches) per exception type, located via
VBAR_ELx, and a separate interrupt controller (GIC) provides the interrupt number.