</>EmbeddedInterview

What is signal integrity and what causes ringing?

HardElectronics & Hardware Basics

Short answer: Signal integrity is about whether a digital signal arrives at the receiver with clean edges and correct levels and timing. Ringing — overshoot and oscillation after an edge — happens when a fast edge travels along a trace that behaves as a transmission line whose impedance is not matched at the ends, so energy reflects back and forth; it can also come from parasitic inductance and capacitance forming a resonant circuit. Problems appear when the edge rise time is short compared with the trace's propagation delay (roughly when the trace length exceeds about 1/6 of the distance the edge travels during its rise time), regardless of the clock frequency.

Rule of thumb: signals travel about 15 cm/ns on FR-4. An edge with a 1 ns rise time "sees" any trace longer than a few cm as a transmission line. Modern MCU GPIOs with fast slew settings have sub-ns edges even when toggled at only 1 MHz.

Fixes

Problem Fix
Reflections on point-to-point lines (SPI clock, SDRAM) series termination resistor (22–33 Ω) near the driver, matching driver impedance to the trace impedance
Unnecessary fast edges reduce GPIO slew rate/speed setting
Long buses (CAN, RS-485) parallel termination at both ends matching the cable impedance (120 Ω)
High-speed interfaces (USB, Ethernet, DDR, MIPI) controlled-impedance traces (50 Ω single-ended, 90–100 Ω differential), length matching, continuous reference planes
Crosstalk spacing (3× trace width), ground between sensitive traces, avoid long parallel runs
Ground bounce good decoupling, solid ground plane, short return paths

Measuring: use an oscilloscope with enough bandwidth (5× the signal's knee frequency ≈ 0.35 / rise time) and a short ground connection on the probe (the long ground clip adds inductance and creates fake ringing).

Firmware-visible symptoms: double-clocked SPI data (ringing on SCLK crosses the threshold twice), random bit errors at high clock rates that disappear at lower rates, and EMI test failures.