</>EmbeddedInterview

Why does a CAN bus need 120 Ω termination?

EasyCommunication Protocols

Short answer: A CAN bus is a differential transmission line (twisted pair) with a characteristic impedance of about 120 Ω. A 120 Ω resistor at each end matches that impedance so signals are absorbed instead of reflecting back and corrupting bits. The two resistors in parallel (60 Ω) also provide the load that pulls the bus back to the recessive state quickly when no node drives it dominant.

Quick check: with all nodes powered off, measure the resistance between CAN_H and CAN_L: about 60 Ω means both terminators are present; 120 Ω means one is missing; much lower means too many terminators (or a short).

Design details

  • Terminate only the two physical ends of the bus, not every node; nodes in the middle connect with short stubs (a few tens of cm at high bit rates).
  • Split termination: two 60 Ω resistors in series with a capacitor (e.g. 4.7 nF) from the midpoint to ground improves EMC by filtering common-mode noise.
  • Missing termination may still "work" at low speed on a short bench setup, then fail in the vehicle or at higher bit rates: a classic bring-up trap.
  • CAN levels: recessive ≈ 2.5 V on both lines (differential ~0 V); dominant ≈ CAN_H 3.5 V, CAN_L 1.5 V (differential ~2 V).