Topics / Communication Protocols / Q18
What is SMBus, and what is I3C?
Short answer: SMBus (System Management Bus) is a stricter variant of I2C used for system management (batteries, power supplies, temperature monitors on PC and server boards): it defines voltage levels, a 25–35 ms clock-low timeout, a minimum 10 kHz clock, optional Packet Error Checking (a CRC-8 byte), standard command formats and an alert line. I3C (MIPI Improved Inter-Integrated Circuit) is the modern successor to I2C: push-pull signalling at up to 12.5 MHz (more in HDR modes), dynamic address assignment, in-band interrupts, and backward compatibility with many I2C targets on the same bus.
SMBus details
- Timeout means a stuck device cannot hold the bus forever (unlike plain I2C).
- Defined transactions: Quick Command, Send/Receive Byte, Read/Write Byte/Word, Block Read/Write, Process Call.
- PEC: CRC-8 (polynomial x⁸ + x² + x + 1) over the whole transaction including addresses.
- SMBALERT#: a shared interrupt line plus the Alert Response Address (0x0C) to find which device raised it.
- PMBus builds on SMBus for power supply control.
- Linux:
i2c_smbus_read_byte_data()etc.
I3C advantages over I2C
| I2C | I3C | |
|---|---|---|
| Speed | up to 1 MHz (3.4 MHz HS) | 12.5 MHz SDR, ~25–33 Mbps with HDR modes |
| Signalling | open-drain (slow rising edges, power in pull-ups) | push-pull for data (open-drain only during arbitration) |
| Addressing | static, set by pins | dynamic address assignment, plus 48-bit provisioned IDs |
| Interrupts | separate GPIO per device | in-band interrupts on the bus |
| Power | pull-up current | lower |
I3C is used for new sensors in phones and wearables, and for DDR5 memory module management (SPD hubs).