</>EmbeddedInterview
Company guides / Texas Instruments

Texas Instruments Embedded Interview Guide

Roles
Embedded Software Engineer, Software Engineer (Embedded), Applications Engineer
Hiring hubs
Bengaluru, Dallas, Richardson, Freising
Focus
C, interrupts, microcontrollers, bit manipulation, projects

Processes differ by team, level and country, so treat this as a typical picture, not a guarantee. Last updated: November 2026.

At a glance

Typical process Online assessment (C, embedded, electronics, aptitude) → 1–2 technical interviews → HR
Main focus C programming (pointers, dynamic memory, output prediction), interrupts, microcontrollers, bit manipulation, computer architecture, your projects
Coding style C snippets and short programs (e.g. a sorting algorithm)
Reported difficulty Rated about 2.8 out of 5 by Embedded Software Engineer candidates on Glassdoor; India campus reports usually call it average

How the process usually runs

Much of TI's embedded hiring in India is through campus recruiting. Candidates describe an online assessment with C programming, embedded concepts, electronics MCQs and debugging problems, followed by one or two technical interviews on C, the projects on the resume, microcontrollers and computer architecture, then an HR round asking why you chose an embedded role. US candidates describe single rounds mixing behavioural questions with technical questions drawn from their projects.

Topics that come up most

Questions candidates reported (paraphrased)

  • Predict the output of this C snippet; questions on pointers and dynamic memory allocation.
  • Explain how an interrupt is handled.
  • Use XOR to compute parity; shift and mask questions.
  • Write a sorting algorithm in C.
  • Which protocol did you use to connect your development board to the motor driver, and why?
  • Why an embedded role rather than a general software role?

Practice questions

These are the questions Texas Instruments candidates most often report, or close variants of them. Each links to a full answer or a coding problem with tests on this site.

  1. What is the memory layout of a C program?
  2. What is the difference between malloc, calloc, realloc and free?
  3. What is an ISR and what are the rules for writing one?
  4. What is interrupt latency and how do you reduce it?
  5. What is polling versus interrupts versus DMA?
  6. What is DMA and how is it configured?
  7. How do you count the set bits in an integer?
  8. How do you choose between UART, SPI and I2C for a project?
  9. How does bubble sort work, and how is it different from binary search?
  10. Set, Clear, Toggle and Test a Bit (coding)
  11. Bit-Banged SPI Transfer (Mode 0) (coding)
  12. Debounce a Push Button (coding)

How to prepare

  1. Know your own projects deeply, down to the peripherals, protocols and registers; TI interviewers dig into them.
  2. Practise C output questions and pointer tracing.
  3. Revise interrupt handling and microcontroller basics (timers, ADC, GPIO), ideally on an MSP430 or another TI LaunchPad if you have one.
Interviewed at Texas Instruments?

Share your experience on the forum and help the next candidate.

Share your experience

Sources: summarised from candidates' public interview reports on Glassdoor [1] [2] [3] [4] [5]